Button Switch 40°C 36W Small Disinfection Lamp PCBA Board

40°C 36W Small Disinfection Lamp PCBA Circuit Board With Battery Connector

Specification

Parameter

1. On-board power input: +5V USB 3.7-4.2V lithium battery

2. Machine power: 4W-36W

3. Output mode:

4.1 Lights: three 2.54 terminals, one empty in the middle

4.2 Battery and fan: two 2.0 terminals

4.3 Working voltage of fan: consistent with battery voltage (it is best to maintain 3V without increasing cost)

How to operate

• Set the lamp power to 1.5W
• The charging current is changed to 500mA, and the corresponding charging power is adjusted to 2.1W
• Gh1.25-2a-dip for motor terminals

The battery connector is as follows. The rest of the positive and negative to confirm with the customer.

A. Directly charge the 3.7V 18650 lithium battery when USB is connected. The charging indicator is red and turns green after full.

B. Press the switch and start the rear light and fan at the same time, until the switch is pressed again and turned off at the same time. No need to turn off the lights regularly. The indicator light is blue at work.

Service

1. PCB Development and Design:

2. PCB Manufacturing From 1 to 32 Layers:

3. Component Sourcing:

4. PCB Assembly:

5. Write Program for Customers:

6. PCB/ PCBA Test.Semi-Automatic

Package

1. Anti-static bubble film shall be used for packaging and packing after piecing together

2. Matters needing attention when packing

1) Considering the force comprehensively, the direction set up after PCBA packing should be the same as that of corrugated carton

2) Avoid the collision between PCBas during packaging; Appropriate placement and bubble film thickness should be selected

Quality inspection

1. Appearance inspection: Check the installation and welding of the original

2. Component push pull test: use push pull meter to check the welding and fastness of components

3. Rigorous testing: Each product must be tested before it can be shipped.